Some useful construction tips for quality control of concrete throughout construction

This article is extracted from an exclusive construction article written by KAUSHAL KISHORE, well know consulting material engineer, and RAKESH SHARMA, Vice President Project of M/s Supertech Limited.

If the concrete is contacted with superplasticizer, it behaves the same way when the amount and type of sulfate included with the clinker. The rheological and setting Behavior are modified on the basis of whether the sulfate is included as anhydrite, hemihydrates, or gypsum. The variations are described by the various rates of dissolution of these sulfates.

It is crucial to keep in mind that all admixtures relevant to the similar generic type may not behave in the same way in concrete due to the differences in the molecular weight, cautions involved with them, chain length, etc. Correspondingly, the similar type of cement generically is dissimilar in mineral, alkali and sulfate contents, and fineness.

As per IS: 456-2000, admixture should not weaken strength of concrete neither mix with the component to develop injurious compounds as well as not enhance the chance for the growth of corrosion in reinforcement. The feasibility, compressive strength and the slump loss of concrete with or without the application of admixtures should be determined throughout the trial mixes prior to applying admixtures. If two or additional admixtures are applied all together in the similar concrete mix, data should be captured to evaluate their interaction as well as certify their compatibility.

The admixtures, the materials for forming concrete and their compatibility can influence the performance of concrete admixture along with superplasticizers. It is essential to analyze concrete admixtures so that it can be exactly used with the concrete to transform materials and mix proportions for being used on the work under proper field conditions.

There four primary components in Cement which range C3s, C2s, C3A and C4AF. Besides, there lots of negligible oxides like K2O and Na2O, MgO and SO3. These are supplied by gypsum and included in the final phases of cement manufacture as a set regulator. If there exist less C3A, superplasticizer would be get immersed in higher amount on C3S and C2S, causing a drop in the strength development.

To read the complete article, go through the following ink
www.engineeringcivil.com/concrete-quality-control-during-construction.html